Hardware and Software you need for this course
Hardware and Software you need for this course
In order to complete the activities of this course, you will need the following Hardware and Software elements:
Hardware
1) Edison Programmable Robot X 1
2) Ultimaker 2+ 3D Printer X 1
3) Amica NodeMCU ESP8266 CP2102 X 1
4) Colored LEDs X 12
5) RGB LED common cathode X 2
6) 5V 1-Channel Relay Module Board X 1
7) Breadboard Full-Size 830 Tie Points White X 1
8) Dupont Jumper Wires 20cm M-M X 10, M-F X 30, F-F X 10
9) Ohmic Resistors 0,25W, ±5% kit for Arduino projects (100Ω X 25, 10ΚΩ X 25, 220Ω X 25, 1ΚΩ X 25)
10) 5V Active Buzzer X 1
11) Push-Button Switches X 3
12) DHT11 Digital Temperature and Humidity Sensor X 1
13) Keyes Photo Resistor Sensor LDR Module KY-018 X 1
14) Keyes Laser Sensor Module for Arduino KY-008 X 1
15) USB 2.0 cable Type-A to micro-USB 1-meter X 1
16) Fan 40x40x10mm 5V X 1
Software
All the necessary software modules you need for the activities, accompanied with installation instructions, are described in detail into the sections of this course. In brief: